DC-420 Network Settings Check

This page contains instructions for location or field technicians. On this page, you can find the instructions on how to perform the network connection settings check in the location where the ITL ClearVision POS is integrated with DC-420.

1. What setup device do you use to connect to the DC Box?

• Mobile device with Wi-Fi (smartphone, tablet, laptop). In this case, move to step 2.
• A computer or laptop with the Ethernet port. In this case, move to step 3.

2. Connect to the DC-420 Network in the following way and then move to step 4:
1. Open up the camera application on your phone, as if to take a new picture.
2. Pan the camera view over the QR code, located on the top of the DC Box.
3. Accept the prompt that has appeared on your phone to automatically connect to the DC Box.
   
   In case you could not connect to the DC-420 Network following the steps a-c described above, do the following:
   Press the power button twice, find the DC-420 Network on the mobile device and connect to it using the password from the sticker or scan the QR code located on the top of the DC-420.

3. Connect the computer or laptop to the DC Box LAN port using the Ethernet cable. Make sure the LAN indicator lights are on.

   If the DHCP to the computer from the DC Box fails, use the following static configuration on the machine:

   • For the DC-420, use the static configuration of 10.20.2.2, netmask 255.255.255.0 and the gateway of 10.20.2.1.
4. Open the browser and navigate to the DC Box IP address as it is displayed in the image below.

   

5. Validate the network setting by clicking the Test connection button. Is your connection status online?

• Yes, the network settings are valid. In this case, move to step 7.
• No, the network settings are invalid. In this case, move to step 6.

6. Repeat step 5 and enter the valid settings specific for the location. Move to step 5.

7. Navigate to the POS Settings step and click the Test connection button.

   (Refer to Activation Guide for visual.)

8. On the home page of CStoreOffice®, hover the cursor over the red connection status icon and click Check Now.

   

9. If the issue persists, repeat step 5. If the issue will persist after it, submit a ticket or contact Support.